Replacement of Components
Grinding Wheel Replacement
3
3-1
BMS500/600doc121319
Replacement of Components
SECTION 3 REPLACEMENT OF COMPONENTS
3.1
Grinding Wheel Replacement
Check the grinding wheel often and change as necessary. Wheels approved for use with the
industrial sharpener are available from Wood-Mizer.
The grinding wheel should be in good condition. Replace if worn, the edges look shiny and/or the
wheel is "burning" the blades.
NOTE:
The grinding wheels have a CBN (Cubic Boran Nitride)
coating.
1.
Before replacing the grinding wheel, shut down and lock out all power to the machine.
2.
Raise the cutting head.
3.
Remove the grinding wheel side guard.
4.
Unscrew the oiler.
5.
Remove the grinding wheel nut, washer and the grinding wheel.
6.
Mount the new grinding wheel. Install the grinding wheel washer and nut and tighten to 44.2 ft-lbs
(60Nm).
7.
Install the oiler.
NOTE:
If the machine is equipped with a 1 1/4" (31.75 mm) wide grinding wheel,
mount the oiler No. 101235. If it has a 1" (25.4 mm) wide grinding wheel, use the oiler No. 100805.
8.
Install the grinding wheel side guard.
3.2
Oil Level
Periodically check the oil level. Add oil as necessary. The oil level should be kept between
8.5 and 10 litres. Use only Wood-Mizer approved oil.
Filter the oil to remove metal shavings before reusing.
3.3
Grinding Wheel Shaft Bearings
Periodically check the grinding wheel shaft bearings for wear and replace as necessary. To replace:
IMPORTANT!
Before servicing, shut down and lock out the power
supply.
!
