Wood-mizer 1987 LT30, Safety, Setup, Operation & Maintenance Manual

Page: 27 / 112

Setup & Operation
Portable Sawmill Setup
Setup & Operation 3087doc041610 2-3
2
1. Unhitch the mill from the vehicle.
See Figure 2-2.
2. Lower and set the front three outriggers. Lift the weight from the locking pin using the jack
handle. Pull the locking pin to release the outrigger and lower the outrigger as necessary.
Secure with the locking pin.
WARNING! Put front outrigger down before moving cutting
head from the rest position. Failure to do so may result in
serious injury.
For Fine Adjust Outriggers (FAOs), lower the outrigger as close to the ground as possible,
then secure in place with the locking pin. Adjust the outrigger base so that it contacts the
ground. To adjust, use the provided wrench to turn the height adjustment nut. Turn clock-
wise to lower. Turn counterclockwise to raise. Maximum adjustment available is 1 1/2”
(3.8 cm).
CAUTION! Do not adjust the FAO outrigger base height
while there is weight on the FAO. Damage to the FAO may
result.
FIG. 2-2