Wood-mizer 1987 LT30, Safety, Setup, Operation & Maintenance Manual

Page: 29 / 112

Setup & Operation
Portable Sawmill Setup
Setup & Operation 3087doc041610 2-5
2
6. Level the sawmill by adjusting the outriggers to raise or lower each end of the sawmill.
Adjust all outriggers evenly to avoid twisting the mill frame by jacking one outrigger higher
than the others.
For FAO(s), fine tune the outrigger base height as necessary. Move the cutting head to
the opposite end of the mill from the outrigger. Raise the entire outrigger (to remove the
sawmill weight from it) and adjust the outrigger base as necessary. Lower the entire out-
rigger and use the locking pin to secure in position.
CAUTION! Do not adjust the FAO outrigger base height
while there is weight on the FAO. Damage to the FAO may
result.
7. Remove the fenders by lifting them out of the slots.
CAUTION! To prevent fender damage, remove fenders
before operating sawmill or loading logs.
8. Raise the two side supports that will prevent a log from falling off the side of the mill when
loaded.