21
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 | www.wolff-tools.de
Rough grinding and abrading
Paper grinding disc grade 16-24, Carbide grinding disc
grade 24, grinding disc 6 stone
Diamond segment silver, Diamond segment brown
Dismounting and milling of soft or moderately
hard screed and levelling compounds
Rotating milling disc, PKD-Split milling disc Diamond seg-
ment, silver
Grinding extremely hard smoothing compounds and
industrial floors, as well as epoxy coatings
Rotating milling disc, PKD-Split milling disc
Diamond segment, silver, PKD-Diamond milling disc
Grinding of parquet and cork Grinding and abrading
timber
Grinding plate MULTI, Paper grinding disc grade 80
Grinding/polishing p cork
Grinding plate MULTI, Grinding gauze grade 180
Grinding of parquet varnish, laquer and old surfaces
Grinding plate MULTI, Grinding gauze grade 60
4.0 Use
4.1 Switching on Fig. C
►
Mount discs or brushes as described above.
►
Put the handle in working position with the lever (1) at
the back.
►
We recommend to position the hand grip in the height
of the users hip.
►
Lift the handle slightly, to make sure the machine
stands horizontally.
►
Keep safety switch (2) pressed.
►
Switch on the machine with one of the levers (3) loca-
ted beneath the grip.
►
Release switch (2).
Note:
lever can only be actuated, if the handle is not in
vertical position. This is a safety feature! The user cannot
control the machine with vertical handle.
After switching on the machine, the handle will move short-
ly to the right.
4.2 Steering the machine Fig. C
Adjusting transportation wheels If the transportation
wheels are in lifted position, the direction in which the
machine moves, is controlled by lifting or lowering the
grip. The more you lift or lower the grip, the faster the
machine runs to the corresponding direction.
► lifting the grip: machine runs to the right
► lowering the grip: machine runs to the left.
If you feel unsafe or cannot control the machine just
release lever (3). The machine will stop at once.
If you have carried out some training, you will be able
to operate the machine with one hand.
4.3 Speed control Fig. C
Adjust the speed of the discs with switch (4). Turning
clock-wise increases the speed, turning anti-clock-wise
decreases the speed. The optimal speed is dependent on
the disc used and the subfloor.
The table below It is meant as guiding principle for the
user. Always test the optimum speed in each case.
Always start at low speed and then increase the speed.
speed range application Recommended
slices and plates
160-200
Sanding of
filler levelling
compounds
Sanding paper,
sanding grid
200-300
Sanding parquet.
Removal of filler
and adhesive
residues
abrasive grids
HM grinding wheels
and system milling
discs
300-400
Polishing of
elastic coverings.
Removal of sea-
lants from elastic
coverings.
Removal of filler
and levelling com-
pound.
pads
scrub brush
System milling
cutter
EN
