5.7
Connecting the Cobra to the mains supply
How to connect the machine to the mains supply:
1. Make sure that the switch ( 1 ) is in the off position.
The machine must be switched off before connecting it to the mains supply.
2. The main lifting lever for the sanding roller ( 2 ) must be folded backward so that
the sanding roller is raised from the floor.
3. Hang the pivoting cable arm into the left or right cable arm bracket as required. Wind the
power cable through the curls at the end of the cable arm ( 3 ) to keep the cable away from
the sanding zone.
4. Connect the motor coupling ( 4 ) of the control cable to the motor.
5. Connect the coupling ( 5 ) of the lamp cable to the plug ( 5 ).
Caution!
Make sure that the abrasive belt is tight before you switch on the motor.
Caution!
Make sure that the sanding roller is raised from the floor before you switch on the motor.
Caution!
Risk of injury if the machine starts unintentionally! Disconnect the machine from
the mains supply when not in use, when changing the abrasive belt, or when carrying out
service work on the machine.
15
03/2009
2
1
3
4
5
