Wolf RT362F, Technical & Service Manual

Page: 36 / 88

RANGES & & R RANGETOPS
Component Access & Removal
4-10
Components Below the Roll Front:
Roll Front Removal
To remove the Roll Front, extract the two screws from
the left and right legs of the roll top. Then extract the
roll front baffle mounting screws from behind the roll
front and lift the roll front and baffle off of the appliance
together. (See Figure 3-23)
Surface Burner Valve Removal
Surface burner valves are held to the manifold pipe with
bolts that pass down through a bracket at the top of the
pipe, and are threaded into the body of the valve.
To remove a surface burner valve, first disconnect the
gas lines from the valve. Then, extract the bolts from
the valve body and mounting bracket. Now pull or twist
the valve off of the manifold pipe.
(See Figure 3-24)
Charbroiler or French Top Valve Removal
To remove a Charbroiler or French Top valve, first dis-
connect the gas lines from the valve first. Then,
remove the ninety degree elbow from the rear of the
valve.
NOTE: Depending on the location of other components
on the manifold, it may be necessary to extract the
valve shaft mounting screws and pull the shaft from the
valve at this point. (See Figure 3-25)
Now, unscrew the valve from the manifold pipe. (See
Figure 3-25)
Figure 3-23. Roll Front Removal
Roll Front
Baffle
Screw
Bolts
Valve
Bracket
Manifold Pipe
Figure 3-24. Surface Burner Valve Removal
Valve
Valve Shaft Mounting Screws
Figure 3-25. Charbroiler / French Top Valve Removal
Roll Front Baffle
under Roll Front
Manifold Pipe