Wolf RT362F, Technical & Service Manual

Page: 50 / 88

RANGES & & R RANGETOPS
Troubleshooting Guide
5-8
PROBLEM POSSIBLE CAUSE TEST / ACTION
U. POOR IGNITION AT
FRENCH TOP
V. NO IGNITION AT FRENCH
TOP
W. UNEVEN HEAT AT FRENCH
TOP
X. NOT HOT ENOUGH AT CEN-
TER OF FRENCH TOP
Y. TOO HOT AT FRONT OF
FRENCH TOP
Z. OVEN BURNER DOES NOT
LIGHT
AA. OVEN BURNER
TEMPERATURE TOO HOT
OR COOL FOR THERMO-
STAT SETTING
Burner head not in position
Partially plugged holes in the burner head
Cracked or damaged electrode or wiring
Check for proper orifice size
Gas pressure
Loose wire connection
Defective electrode
Defective spark module
No power
No gas
Unit not level
Flame ring missing
Outer plate installed backwards
Defective glow coil igniter
Defective bi-metal valve
Loose or broken connection between com-
ponents
Defective thermostat
No power
No gas
Oven burner thermostat out of calibration
Locate per owner’s manual and advise owner
Clear as necessary
Replace electrode or wiring
Check orifice number stamped on orifice
Check gas pressure with a manometer
Check per wiring diagram
Replace electrode
Replace spark module
Check outlet and circuit breaker
Check gas pressure with a manometer
Level unit from front to rear and side to side
Place as shown in owner’s manual and advise
customer
Turn outer plate in proper direction
Replace if not drawing 3.3 to 3.6 amps. See
procedure in technical section
Replace if not drawing 3.03 to 3.3 VAC. See
procedure in technical section
Check all connections per wiring diagram
Check continuity at the thermostat and replace if
defective.
Check outlet and circuit breaker
Verify that there is gas to the appliance. You
may have to also check bimetal valve. Also
check shut-off valve on manifold to verify it is in
open position.
Calibrate oven burner thermostat (See instruc-
tions in Tech Data section of manual)