© 2006 Wohler Technologies Inc. ALL rights reserved
24
AMP-S8
User Manual P/N
821640
Rev-
B
User Interface Function Guide
Section 2:
Operation
Standard Input Source Selection:
INPUT Button
In
Normal Operational Mode
, each press of the
INPUT Button
cycles through the input selections, each being visible in
the
LCD Display
in turn as shown:
•
Analog
•
AES1
(Unbalanced)
•
AES2
(Balanced)
•
SD-SDI1
or
HD-SDI1
(Not available in
DA
model)
•
SD-SDI2
or
HD-SDI2
(Not available in
DA
model)
The selected input is enabled when it appears in the
LCD display
. In models without
SDI
capability, only the
Analog
and
AES
inputs are cycled through.
Default Auto-Monitor Mode
Normal Operational Mode:
This is the default operational state of the monitor when selection modes, operational state modes, display modes, and setup
modes are
not
enabled. In this mode the
LCD display
indicates the current operational status in regard to input source and
channel selection. The
Normal Operational Mode
is enabled by default at unit power up.
Default Modes
(Continued)
Selection Modes
Preset Mode Selection:
PRESET MODE + INPUT Button
When
Preset Mode
is enabled (see page
29
), each press of the
INPUT Button
cycles through the preset names as previously
configured by the user. If an active (selected) preset is made inactive by selecting other channels or
SDI
groups for monitoring,
then pressing the
INPUT Button
will revert to the most recent preset state (as long as
Preset Mode
is enabled).
See
Preset Mode Enable
on page
29
for more information on how to select and set this parameter within the
Setup Mode
menu (page
28
).
