2.3 Internal connectors, interfaces
1
–
Enclosure bottom part (ABS plastic with IP67 protection and 6 holes
–
where the
PCB can be fastened into the enclosure by screws at holes)
3
–
Fixation screws of the enclosure to close and lock the top cover of the enclosure
4
–
Special filled, longlife battery (Lithium-Thyonyl-Chloride, 3.6V DC, CR14250 type)
5
–
SIM card slot (for micro-SIM, 3FF type)
6a
–
Input cable connector (to J11)
–
for meter pulse output(s), S0-type
7
–
Connection interface for MBus additional board (5-pins, marked by J17)
8
–
Power ON pins (2-pin connection, make short to start the device, allows the battery
power source for the device
–
connector marked by J5)
10
–
Tamper switch (for sense the cover / enclosure top remove)*
-
this feature is
currently inactive
11
–
Configuration port (5-pins, for local configuration and firmware update, J12)
LEDS
–
Operation LEDs
4
5
1
–
A
8
–
A
10
6a
LEDS
11
7
