2.
Installing the router
2.1
The very first startup
The router has a supercapacitor inside which can protect the device against short (<5sec) power
outages. Therefore this part can be charged and it can be exhausted after an outage or if you store
the router for months without connecting power source or using.
In these cases you cannot start the router as usual by adding the DC power supply only, because
only the PWR led will be active (lighing by
green
), but the router won’t start further.
First, you must start the router by the adding the power source and pushing the Reset button
(No. 11) for 2 seconds by a sharp object (e.g. by a pen) – while the ON led will be also active (all
the two leds are lighting by
green
colour) – then you can release the Reset button.
Then the router will start immediately and charging the supercapacitor (SUPERCAPACITOR
CHARGE led will be also active – by
yellow
colour).
Next time you don’t need to push the Reset. You can stop it by removing the power source and
start it by adding the DC power.
