WLD-TEC Flame100, Instruction Manual

Page: 20 / 52

20
Read these instructions carefully to familiarize yourself with the product. Please retain
these operating instruction for future reference.
Use
Safety Bunsen Burner for Microbiology, Cell Biology, Dental
Labs, etc. Ideal for heating and flame sterilizing.
All users who have been assigned to use this device must have read
and understood these operating instructions or have been instructed
by an expert user so that this device can be used safely without
causing danger.
ATTENTION: OPERATE THIS SAFETY BUNSEN BURNER UNDER
CONSTANT SUPERVISION ONLY!
!
Safety Precautions
• On unpacking the unit, check for possible transportation damages.
Do not operate the unit if damages are visible.
• After use or for any longer period of time without attendance, turn
the main gas supply off. To depressurize gas hose keep the
main gas supply off and activate the burner again until the flame
extinguishes in order to burn the residual gas. Afterwards turn off
the gas burner at the function knob (1).
• All gas connections must be adequately tightened (left-hand thread).
Ensure gas proofness with suitable test equipment. DO NOT seal up
the thread of the gas connection (10) of the safety bunsen burner
with Teflon tape, etc.
• BEFORE using the device carefully check the gas feed tube for leaks.
Check this even if the device has been installed by your distributor.
To do this, carry out all the procedures mentioned in these operating
instructions (see paragraph 1.).
• In the event that gas can be smelled: immediately turn off the gas
supply to the device. Extinguish any open flames. Pull out the mains
plug. Check all gas connections for gas proofness. If the smell of gas
persists, the appropriate authorities must be notified (janitor, gas utility
company, Fire Brigade).
LEAKING GAS CAN CAUSE A FIRE OR AN EXPLOSION. THIS MAY
RESULT IN SEVERE INJURIES, FATAL ACCIDENTS AND DAMAGE
TO PROPERTY.
• The device can be dangerous if operated or used in an incorrect
manner by untrained staff.