26
Translation of the original operation manual
DUOMIX 230
DM230_BAoDB_en_1307 · rs
Transport, installation and assembly
4 Transport, installation and assembly
The unit has left the factory in flawless condition and was appropriately packed
for transport.
Upon arrival you should check the unit for completeness and any apparent
transport damage
.
4.1 Transport
Please follow these notes when transporting the unit:
➤
Ensure sufficient load bearing capacity of lifting gear and lifting tackle when
loading the unit. You find the dimensions and weights of the unit on the
machine card.
➤
The unit must only be lifted by the attachment points for lifting equipment.
➤
When using a forklift make sure that the fork tines are long enough.
The fork tines must reach completely through each of the two opposite
forklift lifting points on the rack.
➤
When transporting with a forklift set the fork tines as far apart as possible,
to minimize the overturning moment.
➤
Attention! Danger of tipping over! Ensure even load distribution to secure
the unit against tipping over.
➤
Do not transport any other objects (e.g. material containers) when lifting the
unit.
➤
Never stand under suspended loads or inside the loading area.
This poses a life hazard!
➤
Secure the load on the transport vehicle against slipping and falling off.
If the unit has already been in use, you should observe the following notes:
➤
Disconnect the entire power supply – even for short transport distances.
➤
Empty the unit before transportation – fluid residues may escape during
transport, despite this measure.
➤
Remove all loose components (e.g. tools) from the unit.
➤
Assemble the parts or fittings dismantled for transport purposes before start
up professionally and in compliance with the intended use.
Summary of Contents for Duomix 230
Page 2: ......
