18
WT-9002 IP65 User Manual
WT-9002 IP65 – USER MANUAL – Rev.2.0 – Technical Support:
COPYRIGHT ©2010 WITURA CORPORATION SDN BHD
Simply sends 3 SMS command as below:
1) *TEL1#4444444444
2) *TEL2#5555555555
3) *TEL3#6666666666
The system will replace the current administrator numbers with the new administrator
numbers and will reply as follow
Example of Returned Message:
TEL1=4444444444
TEL2=5555555555
TEL3=6666666666
It is possible to disconnect the call being made from the call point to prevent the
network holding the call after hanging up by using the following prompt on the handset
whilst the call is active.
Press *4# and the call will be disconnected.
To program numbers in the list via voice you would use the following prompts once you
have called the unit and it has answered assuming you are programming in the following.
Explanation of how it works:
In WT-9002 memory, there are total of 10 lists with list number 0 – 9. The list number
also represents the last digit of a phone number and each list can store up to 100 phone
numbers. If the guest number is 2222222226, it will automatically store the number
into list number 6. If the last digit of the guest number is 8, then it will be stored in list
8.
Example:
To program 2222222226 into the list:
Press *5# (A short beep ~ success)
Then you can input the phone number 2222222226# (A short beep ~ success)
4.9
DISCONNECTING THE CALL VIA THE HANDSET
4.10 PROGRAMMING THE GUEST LIST VIA VOICE
