28
Safety
Figure 2
-
22 Anchor points to which shackles are to be attached
3.
Fasten shackles securely on each appropriately rated lift sling.
4.
Securely attach the slings to the appropriately rated lift beam, which was previously installed on
the overhead crane.
5.
Proceed with the lifting of the body.
Make sure to raise both ends of the body at the same time.
Safety Precautions To Be Taken When Working
With Hydraulic Systems
As with all hydraulic systems, it may be necessary to periodically check and adjust the pressure relief
settings. It may be that a major hydraulic component has been changed, the unit is not performing in
terms of payload, or the unit has recently been put into service and the system requires adjustment
following a run-in period.
Please take note of the following:
Mechanics must have previous hydraulic knowledge as serious injury or death can result from
following improper procedures.
Human skin can be easily penetrated by high pressure oil (2000 PSI and above). Failure to take
appropriate safety precautions may result in serious injury or death.
There are extreme overhead dangers if equipment is not properly supported when servicing
sections on the hydraulic system.
Warning!
If a hydraulic component has to be changed or a repair to the hydraulic system is needed,
always apply the lockout/tagout procedure first (see
Locking Out and Tagging Out the
on page 21). Failure to do so may result in severe injury or even death. Be sure to
fully read and understand this chapter before doing any repair.
Summary of Contents for FEATHERWEIGHT
