Multiplexing
155
It is highly recommended that dielectric grease be applied to connector.
3.
Check the condition of the harness and ensure that it is not secured too tight with tie-wraps,
which may pull the wires back within the connector.
Figure 9
-
20 Connectors, terminals and harness
4.
Check all ignition (power) and grounds to the module and also check the CAN_H & CAN_L
side to the module.
4 a.
Verify all power supplies (IGN) to the module, if there is a suspicion that power is
intermittent check the ignition relay, which is located next to the battery box.
4 b.
Verify that grounds are good to the module. Need to isolate and check the resistance on the
individual grounds.
Check the CAN_H & CAN_L wires and verify that there is 60 ohms resistance. If there is not, this
will cause connectivity issues to the specific module.
Connectors
Terminals
Harness
Summary of Contents for FEATHERWEIGHT
