Witt W5-450MF, User Manual

Page: 79 / 86

78
Installation
After connecting the electricity, check that all the electrical parts of the oven are working.
Installation must only be performed by a fully qualified electrician who must ensure regulations in force for
installation are observed.
Installation
This information is intended for the installer, as the person responsible for assembly and electrical
connection. If you install the oven yourself, the manufacturer will not be held responsible for any possible
damage.
Before Installation.
To unpack the oven, pull the tab located on the lower part of the box and to move it, hold by the lateral
handles and never by the oven door handle.
The adhesive used for the plastic covering of kitchen furniture must be able to withstand temperatures up to
85ºC.
Always make sure that this appliance is fitted by a competent electrician.
Before you start
•
Always make sure that you have carefully read through the installation pages of this book – careful
planning at the beginning will ensure a quick and easy installation.
•
Take care when moving this appliance, it may be heavier than it looks! If you need to lift the appliance,
make sure you use an appropriate lifting method.
•
Soft, or uneven flooring may be damaged unless the appliance is moved with care.
•
Do not attempt to move the oven by pulling on the handles or doors, we recommend that you open the
door and grasp the frame of the cooker. Please wear protective gloves for this, and make sure the door
cannot trap your fingers.
•
To fit multi-function appliances it is important that the back part of the unit, corresponding to the shaded
must be free from any projections (pipes, sockets etc).
•
Please make sure that you have enough space for your appliance, use the table and diagrams shown to
help determine this.
Warning: This appliance must be earthed
•
Leave the appliance in the base tray packaging until you are ready to install it. When you remove the
appliance from the base tray packaging, take care not to damage it.
•
Whilst every care is taken to eliminate burrs and raw edges from this product, please take care when
handling - we recommend the use of protective gloves during installation.
•
Please note that all dimensions and sizes given are nominal, some variation is to be expected.
•
If this appliance is to be installed near to a corner where the adjacent cabinets run at right angles forward
of the appliance, there must be a gap of at least 90mm between the appliance and the cabinets, to prevent
overheating of the cabinets.