- 28 -
Settings COFDM
Hierarchical mode
(Key code XX41)
only at
Channel A*
Channel B**
OV75M A/B=channel
476 MHz= input frequency A/B
479.00=output frequency A/B,
<1.0e-4=BER, alternating display
Channel
OV75M
V1.00
busy
Input channel
A/B
Mode*
Remux,
Remultiplexer mode
NonHier
, NonHierarchical mode
Hier
, Hierarchical mode. chA/B one of the modules gets
the priority
OV75M A
V1.00
busy
Please set all parameters of the frontend modules
F-Out*
45-862 MHz,
0.25-MHz steps
loop
=
Loop thru mode,
single
= single output
Out-Att*
0-16 dB
output level, 1-dB steps
OutConf*
Out-BW*
HP Progr*
MUXStat
Sum of selected programmes ch A/B
MUX on
- displaying status
QAMMode*
5, 6, 7, 8 MHz
=
output bandwidth
LP Progr**
Displays the list of transponder name. Select low priority
program with
. A
*
confirms the selection. Select
programme per channel.
T=TV; R=R
adio; = encrypted
LP CR**
1/2, 2/3, 3/4, 5/6, 7/8,
Low Priority Code Rate
Displays the list of transponder name. Select high priority
program with
. A
*
confirms the selection. Select
programme per channel. Indication of
!Overfl
.shows:
(total data rate to high)
T=TV; R=R
adio; = encrypted
16 QAM, 64 QAM, QPSK
type of modulation
Output settings
NIT-Ins
On, off
Network Information Table insertion
NetName
network name
7 digits
off or set HEX code
0 x 0000 Network identifier
F F F F
OrgTsId
NetwId
off or set HEX code
0 x 0000 Transport Stream identifier
F F F F
TsId
A
off or set HEX code
0 x 0000 Original Transport Stream
F F F F Identifier
B
GB
Note:
Settings marked with A
Some SetTopBoxes on the mar-
ket requires additional informa-
tions about NIT to scan correct
Transport Stream.
Available from
COFDM version 11
..
Factory setting: on
Hierarchical mode supports two
frontend modules ch A/B. Set
priority to one of them.
