18
INST
ALLA
TION
INSTALLATION - Step 6 - Electrical Connections to the Control
WARNING:
Do not apply power to these
terminals as this will damage the control
Connect the two wires from sensors to terminals described
below:
1) Outdoor Sensor S4 wires to Com and Out S4
terminals (16 and 17)
(See fig. f)
• Measures outdoor air temperature
2) Boiler Return Sensor S3 wires to Com and
BRet S3 terminals (13 and 14)
(See fig. g)
• Measures boiler return water temperature
3) Mixing Supply Sensor S1 wires to Com and
Mix S1 terminals (13 and 15)
(See fig. h)
• Measures the mixed supply temperature after the mixing
system pump (P1)
NOTE:
Sensor is normally attached
downstream of system pump (P1).
4) Unoccupied External Timer or Switch wires
to UnO Sw and Com terminals (12 and 13)
(See fig. i)
• When continuity is detected between terminals 12 and 13,
the control registers an unoccupied signal (Night mode)
Sensor and Unpowered Connections
Com
13
14
BRet
S3
Boiler
Sensor
g
Com
13
BRet
S3
14
Mix
15
S1
h
Com
16 17
Out
S4
f
UnO
Sw
12 13
Com
i
Summary of Contents for proMIX 101
