R-1 Micro
& Micro Lite
Receiver
Installation
The antenna is concealed within the unit, no external antenna is
required.
Note: The R-512 Micro Lite does not have battery backup.
1 When not operating from internal battery power, the unit re-
quires a low voltage input: 12 to 24VDC supplied via the RJ45
socket.
2 If required, attach the supplied trussholder bracket to the rear of
the unit (see page 12).
Linking and unlinking
Please see left for operational details.
Battery operation (not Micro Lite version)
When fully charged, the internal battery can support operation for
up to 8 hours. The
Level
indicators show battery charge when the
BATT
indicator is ON. Use the button on the end panel to change
between battery operation (green indicator) and external power
(red indicator). When no external power is supplied, this switch can
be used to cease battery operation and power down the unit.
W-DMX
made in sweden
Level
Radio
Batt
Wireless Solution
Sweden AB
FUNCTION
POWER
DATA
RX
TX
CTRL
LINK
LINK
OFF: Not linked to a transmitter
ON: Linked to a transmitter
RAPID FLASH: Linking with a transmitter
RADIO
ON: Indicates that
Level display is
showing signal
strength
BATT
ON: Indicates that
Level display is
showing battery
charge
FUNCTION
Press for 5
seconds to unlink
from transmitter
Level
Provides alternate indications
of radio signal strength & battery charge
DATA
ON: Receiving DMX data
TX
&
CTRL
Not used
POWER
OFF: Switched off
or using battery
ON: External
power input
FLASH: Charging
battery
DMX out, DC power in (RJ45)
1: DMX-
5: +12-24VDC
2: DMX+
6: n/c
3: n/c
7: Signal GND
4: +12VDC 8: DC GND
Fade button - Press to fade off/on the top
panel indicators. Note: When running from the
internal battery, the indicators fade off auto-
matically to conserve power. Not Micro Lite.
Battery button & indicators - Press to change
between battery (green indicator) and external
power input (red indicator) operation. Not
Micro Lite.
DMX out,
(XLR female 5pin)
DMX Interface
Transceivers on bus: 32 (max)
Data rate: 250 kbps (max)
ESD protection*: ±15 kV
DC input
12-24VDC 1,5A (maximum)
Compliance declarations
ETSI: EN300 328 & 300 826
EMC: EN301 489-17
CE: EN60950
FCC: UQT-WDXOEMPCBF
IC: 6812A-WDMXOEM
ARIB: 06215559/AA/00
RF characteristics
Output power:
20 25** dBm
100 300** mW
Frequency range:
2402 to 2479 MHz
Channel bandwidth: 1
Sensitivity at 0.1% BER:
-95dBm
* Slewrate limited for
minimum of EMI in unter-
minated networks.
** Only in FCC output
power mode.
Package Contents
In addition to this manual:
1 pc, BlackBox R-512 Micro
or Micro Lite
1 pc, RJ45 power cord
1 pc, Trussholder bracket
