Wi-Ex
zBoost YX500/510 Series Installation Guide
iv
Outdoor Installation of the Signal Antenna
Grounding the Signal Antenna
If you decide to install the Signal Antenna outdoors, it must be properly grounded.
This will help protect your property against lightning strikes during a lightning
storm.
The installation must be in accordance with Article 810 of the National Electric
Code (NEC). A listed antenna discharge unit must be provided for the lead-in
coaxial cable per NEC article 8.10.20 or the shield of the coaxial cable must be
permanently and effectively grounded in accordance with NEC article 8.10.21.
Please consult a professional installer or electrician for more information.
Additional instructions and hardware are also available in the Wi-Ex Outdoor
Installation and Grounding Kit (Part# YX012).
Securing Cable With a Drip Loop
If you install the Signal Antenna outdoors, create a drip loop with the coaxial cable at
the point where the cable enters the building through an outside wall. This can be
done by twisting and securing the cable into a loop (no less than 4” across) near the
entry point. This will help prevent moisture from gathering at entry point and leaking
into the building. Consult a professional installer if you need more information.
Additional instructions are also available in the Wi-Ex Outdoor Installation and
Grounding Kit (Part # YX01
2
).
Pre-installation Guidelines
Outdoor installation is preferred when a home is In an area of weak outdoor signal
area (generally 1 to 2 bars as indicated on the cell phone).
Avoid any drilling or nailing directly into the roof. This could allow water to leak into
your home and cause damage.
Choosing to mount the antenna into fascia will not compromise your roof and
places the antenna higher above ground level.
Note:
The zBoost YX500/510 Series is fully
automatic. The Install, Signal, and Power
lights on the Base Unit are not buttons.
There are no buttons to press on the
Base Unit.
wpsantennas.com
(877) 594-5766
