Wi-Ex
zBoost YX500/510 Series Installation Guide
8
Warning
:
The zBoost YX500/510
Series base unit MUST
only be used with the provided power adaptor.
Use of other power adaptors will void the
warranty and may damage the unit. Use of
other equipment is not FCC approved.
Installation Tools Needed
The following tools are needed to install zBoost:
•
#2 Philips screwdriver
•
Cellular phone operating in the band supported by your zBoost unit
•
Drill (may be required for outdoor or attic antenna installations)
Installing Your zBoost
Installing the Signal Antenna
Choosing the best location for installation of the Signal Antenna provides the
best performance and the largest area of improved signal. Determine the
location which provides the strongest signal using the signal strength indicator
on your cell phone. Find the location which provides the most bars of signal
strength and locate the Signal Antenna at that location.
Choose one of the following 3 options for installing the Signal Antenna
:
Easiest Installation
: Inside of a window
Locate a window where you get signal.
1. Mount the Signal Antenna above the window
2. Place the Base Unit across the room (15 feet away) where you want
to create a Cell Zone™.
3. Attach the coaxial cable to the signal antenna.
4. Attach the coaxial cable, which should already be attached to the
Signal Antenna, to the Base Unit.
5. Attach the Antenna to the Base Unit and position the antenna
vertically.
6. Set the Base Unit on a furniture piece.
7. Attach the Power Supply to the Base Unit and plug the power supply
into an outlet. See the Troubleshooting section if a Red light
lights up.
wpsantennas.com
(877) 594-5766
