Before working with the machine
3
2.3 Electrical Safety
The electrical safety of this machine is guaranteed only if it is connected to a correctly installed
protective circuit and a residual current circuit breaker. It is very important that this basic safety
requirement is tested and in case of doubt the house installation is checked by a qualified elec-
trician.
Winterhalter cannot be held responsible for damage caused by a missing or broken earthing
system (e.g. electrical shock).
2.4 Safety Instructions for Maintenance and Repairs
Maintenance work and repairs may only be performed by authorized professionals. Improper
maintenance or repairs may cause significant danger for the user, for which Winterhalter is not
liable.
When performing maintenance and repair work, unplug the machine from the power network.
Electricity consumers (heating element) are under voltage until the on-site mains disconnect
switch has been operated.
Only original Winterhalter spare parts may be used for maintenance and repairs. If original
spare parts are not used, the warranty is invalidated.
A damaged or leaking machine can endanger your safety. In case of defects, switch off the ma-
chine immediately. Switch off the local mains separator (main switch). Only then is the machine
without power.
Do not operate a damaged machine. In case of defects resulting from an unknown cause,
switch off the machine and do not switch it on until the defect has been rectified.
Contact your installer or electrician if the on-site water or electricity supply is the cause of the
malfunction.
Notify an authorized service technician or your retailer if another fault has occurred.
If the mains cable of this device is damaged, it must be replaced by the Winterhalter or its Cus-
tomer Service or another qualified person in order to prevent hazards. The mains cable must be
H07 RN-F type or equivalent.
2.5 General safety notes
Read through the safety notes and operating instructions in this manual carefully. Retain the
operating instructions for future reference. Winterhalter Gastronom GmbH does not assume lia-
bility or warranty in case of non-adherence to these safety and operating instructions.
Use the dishwasher only after you have read and understood the operating manual. Allow the
Winterhalter Customer Service Department to provide information about the operation and func-
tioning of the dish washer. Always operate the machine as described in these operating instruc-
tions.
Train the operating personnel as regards handling the machine and inform them about the safe-
ty notes. Repeat the training sessions at regular intervals to prevent accidents.
For your safety, test the local fault current circuit breaker (FI) regularly by pressing the test but-
ton.
Close the on-site water stop cock after the work is complete.
Switch off the local mains disconnector after the work is complete.
3
Before working with the machine
Have the machine set up by an authorized service technician or your dealer (
13).
Have the machine connected as per the locally applicable standards and the regulations by authorised
mechanics (water, waste water, electrical system) (
14 and
15).
After connecting the water and the power properly, contact the relevant Winterhalter dealer or your dealer
for the commissioning of the machine and for providing training in its operation. Get yourself and your op-
erating personnel trained in the operation of the machine.
Summary of Contents for PT 500
Page 1: ...Rack pass through dishwasher PT 500 Operating instructions ...
Page 2: ......
Page 24: ...Electrical connection 22 15 3 Connection diagram ...
Page 29: ......
