DRAFT INDUCER - INSTALLATION
Continued:
Draft Inducer Installation onto the stove pipe.
Use the manufacturer’s template and instructions that come with the Draft Inducer.
See Figures 1 and 2 on previous page for Proper Location of the Draft Inducer.
It is recommended to perform the following instructions with the stove pipe removed.
As Per the Draft Inducer’s Manufacturer’s Instructions:
Drill four (4) 7/32” holes for speed nuts.
Cut out the rectangular hole for the Draft Inducer as per template. (See Figure “A”)
Install speed nut clips over each of the four drilled holes.
Insert curved edge of the fan housing into the pipe in the direction of airflow and secure unit to pipe
with screws. (See Figure “B”)
Important: All stove pipe connections must have at least 30mm (1 3/16”) overlap when joined to-
gether and a minimum of 3 fastening screws per joint to prevent separation of the connector
pipes.
Continued on next page…
