3
REV. 5/07
Quick Reference Guide
Your Winegard Movin’ View
TM
satellite System has been designed to be the most user-
friendly Mobile Satellite Antenna on the market today. Upon installation of the antenna,
or after changing satellite service provider, simply set the switches inside of the dome to
the settings shown in the Operation manual. These switches enable the dish to locate the
proper satellite for your service provider and to be set for the proper installation option.
Simply set the switch, and you’re done! Your Winegard Movin’ View
TM
antenna will locate
the proper satellite with just the flip of a switch.
Mounting Instructions
It is essential to mount your Movin’ View
TM
Automatic System in the proper position and
orientation on your RV roof to ensure proper operation. Choose a location on your roof
clear of obstruction and close to your receiver and power source.
To ensure proper tracking with your Movin’ View
TM
antenna, you must mount the unit so
that the unit is centered on the centerline and cables exit either towards the front or back
of the RV. See Figure 1c below.
Switch Settings
After mounting the Movin’ View
TM
System to your rooftop, you must set the Movin’ View
’
s
switch settings for the mounting option chosen and for the satellite television service
provider. The chart below lists switch settings. See page 3 of the Operation Manual for
detailed instructions.
MV3500T
(#1 represents Switch DOWN; #0 represents Switch up)
Sat. Rcvr. Mt. Option Switch Set Position
.......................................
1 2 3 4 5 6 7 8
DIRECTV
A
0
0
0
0
0 0 0 1
(FACTORY PRESET)
DIRECTV
B
1
0
0
0
0 0 0 1
DISH NETWORK A
0 0
0
1
0 0 1 1
DISH NETWORK B 1
0
0 1 0 0 1 1
EXPRESSVU
A
0
1
0
1
1
0
1 1
EXPRESSVU
B
1
1
0
1
1
0
1 1
1 2 3 4 5 6 7 8
SWITCh SETTINGS
OPTIONS
0= UP 1= DOWN
1 = DOWN
0
= UP
0 0 0 0 0 0 0
1
FACTORY PRESET FOR DIRECTV SHOWN
MOUNTING OPTION A
CABLE EXIT REAR
ALIGN FEET EXACTLY
SQUARE ON CENTER LINE
OF vEhICLE AS ShOWN
Mv-3500
BACK OF
vE
hICLE
FRONT OF
vE
hICLE
Mv3500T
CABLE EXIT FRONT
Mv-3500
BACK OF
vE
hICLE
FRONT OF
vE
hICLE
FIGURE 1C
MOUNTING OPTION B
ALIGN FEET EXACTLY
SQUARE ON CENTER LINE
OF vEhICLE AS ShOWN
Mv3500T
DirecTV
®
rec
eivers must be set to the two, satellite oval dish setting. Refer to your receiver manual.
DISh
Network and Bell ExpressVu receivers must either have the check switch set for SW42 or unknown, no switch
found. See page 5 in Operation Manual.
The satellite system has two modes of operation; Tracking Mode and
Sleep Mode. When you first turn the unit on, it
enters Tracking Mode
. In this mode the unit will search and actively follow the satellite as the vehicle travels. Tracking
mode ends when the unit has successfully finished its search and the vehicle has not moved for six minutes.
Sleep Mode
, is the unit at rest mode. During Sleep mode the dish will toggle between primary and secondary satellites
as you change channels with the remote. The unit enters Sleep mode about six minutes after a successful search if
stationary, or six minutes after the vehicle stops moving.
