1-800-777-8466
Top Exhaust Gasket
• Cut a rectangular opening inside at the rear of the cabinet with the ¼” clearance inwards to the width and height of the
cooling unit. By not going through, leave 1/2” lip inside at the wall to place the gaskets.
• If top exhaust, cut another rectangular opening at the top of the cabinet to the length and width of the top exhaust opening.
• Mount the gaskets on the four mounting sides.
• If top exhaust, place the gaskets along the top openings at the top of the cooling unit.
• Place the cooling unit to a flat and stable place.
• Then move it on the top of the rack temporarily.
• Move the cooling unit towards the mounting sides and push to compress the gasket.
• Locate the 3 brackets (6) and use 7/16” wrench to tighten the 3 screws (7).
• Screw the exhaust and fresh air grille on the opening from the rear side of the cabinet.
• If top exhaust, install the top exhaust grille at the top of the cabinet.
• Plug the cooling unit in receptacle.
• Screw the 2 screws (4) and locate the light on the ceiling.
• Plug the light in receptacle.
• Plug the wine cabinet.
3. Electrical Cord:
• Because of potential safety hazards under certain conditions, we strongly do not recommend the using an extension cord.
However, if you still select to use an extension cord, it is absolutely necessary that it is a UL LISTED 3-wire grounding type
appliance extension cord. The marked rating of the extension cord should be 115 V, 15 A. or equivalent and not greater than
15ft in length.
GASKET
12
