Windsor EM-21A, Instruction Manual

Page: 5 / 26

ELECTRA-MATIC
Page 5
of
26
en screws holding tank support bracket
to frame and tip tank assembly forward.
CAUTION: Be sure ELECTRA-MATIC IS
UNPLUGGED FROM WALL OUTLET AND
THAT TANKS ARE EMPTY.
TO REMOVE TANK ASSEMBLY FROM
disconnect internal hoses, pull
pins from front and tip off.
This digital recorder keeps track of
operating hours.
It
is wired into the
vacuum motor circuit so that all opera-
tions using the vacuum are recorded.
IF YOU USE AND CARE
FOR
YOUR
ELECTRA-MATIC AS HAVE
IN THIS SECTION, IT YOU
YEARS OF TROUBLE-FREE SERVICE.
SERVICING THE
DRAIN AND CLEAN TANKS
SOLUTION TANK
-
(To remove unused
solution).
1. Plug extension cable from machine into
2. Remove hose from shoe and pull
properly grounded outlet.
through guide on handle
1 .
3. Position dome on waste water tank to
allow hose to be lowered into
solution lank.
4. Lower vacuum lever to turn on
motor. Vacuum solution into waste
water tank. Use water hose to rinse
inside of tank. Reattach
hose to
shoe when finished.
WASTE WATER TANK:
2.
1. Remove drain hose keeper on
bottom of control and put hose
over drain or bucket.
2. Use water hose and detergent to clean
inside of tank.
TANK REMOVAL
1. Empty and waste water tanks.
3.
2. Remove inspection plugs. Loosen
screws holding tank support bracket
to
frame and tip tank
forward.
4.
5.
3. Tilt tank forward and disconnect hoses
from tank and motor.
6.
4. Remove front hinge pins and set tank
aside.
5