Windsor EM-21A, Instruction Manual

Page: 4 / 26

ELECTRA-MATIC 11
Page 4 of
26
TO
USE FLOOR AND HAND
TOOLS
the ELECTRA-MATIC, attach solution hose
to male attachment at lower right rear of
machine, and the vacuum hose
to
the
clear plastic recovery
Release the vacuum lever to the forward
to create
turns on when valve at attachment
is
activated CAUTION. Switches on
ELECTRA-MATIC control panel must
remain
"off
CLEANUP AND
WARNING: To shock
do
expose to rain. Store indoors
EMPTY RECOVERY TANK directly into
floor drain
or
into bucket for disposal
Flush inside of recovery tank with clean
water Clean the inside of the recovery
dome
EMPTY
SOLUTION
by detaching
recovery hose at floor tool and placing
into solution tank with vacuum motor
running
CAUTION Never allow recovered solutlon
to remain in tank when not in use, nor
allow
unused to remain in solutlon
tank when in storage
WIPE the enbre outside of the ELECTRA-
a cleaning cloth. using warm
water and mild soap
STORE ELECTRA-MATIC with recovery
shoe the "up" position Place
recovery dome upside down in recovery
tank as shown to permit drying of
gasket
and the inside of the tank
INSPECT
screens in solutlon and re-
covery tanks Clean with
brush if necessary
EVERY TWO WEEKS:
CLEAN SOLUTION SYSTEM by diluting
2
gallons of clean water with a quart of
white vinegar (acetic acid) in ELECTRA-
tank
Run solutlon
the system with the machine parked over
a drain This procedure will free the
system of harmful buildups which could
eventually cause it to plug
EVERY OPERATING HOURS:
OIL FRONT WHEEL BEARINGS
by removing hub cap and snap ring on
axle Slide wheel off axle and apply 6
drops
of
oil to bearings
REMOVE VACUUM MOTOR
inspect
carbon brushes for wear
If
worn
to
3/8
inch, the brushes should replaced See
service section for instructions
WIPE
clean all working when
exposed for vacuum motor inspection
PARTS IN-
SPECTION
inspection plugs,
4