Windsor CV24, Operating Instructions Manual

Page: 37 / 141

37
Maintenance
Brush Deck
The dual cylindrical head is designed to agitate the
carpet while vacuuming. The first brush pushes debris
backwards. The second brush, brushing forward picks
up debris and throws it into the debris tray.
NOTE: The brushes should wear evenly side to side.
Brushes should be replaced as a set when bristle
length wears to height of yellow PerformAlert™
bristles.
Brush Removal
The brushes are removed from the right side of the
machine.
1. Release door spring clips and raise the brush door.
2. Slide the brushes out the side opening. Remove
bearing cap. Clean bearings and cap.
Brush Installation
1. Slide brush through door opening and onto drive
shaft. Make sure it is fully seated and is driven by
the deck system.
2. Rotate the brush end caps until the indicator lines
on the ends are vertical.
3. Lower the brush door and secure with spring clips.
Debris Tray Removal
1. Release the debris tray spring clip.
2. Slide the debris tray away from machine.
Debris Tray Installation
1. Slide the debris tray into the debris tray mount
notch.
2. Secure with debris tray spring clip.
Belt Replacement
1. Remove three (3) cover screw and cover.
2. Push belt tensioner to the left as shown to release
belt tension. Remove belt and discard.
3. Thread new belt through pulley’s and tensioner.
4. Re-install cover.
NOTE: Belt must be installed with lettering facing out.
If installed incorrectly this may cause excessive noise
SPRING CLIP
VERTICAL INDICATOR LINE
SPRING CLIP
SPRING CLIP
COVER
BELT TENSIONER
BELT
86398780 Operator Manual iVac 24 ATV