Windsor Clipper Duo, Operating Instructions Manual

Page: 29 / 76

29
Maintenance
Scrub Head
The dual cylindrical scrub head is designed to scrub
chemical into the carpet. The two counter rotating
brushes raise the pile of the carpet, giving it a lush
groomed appearance.
The rear brush is the stiffer brush and is intended to
scrub deeper and help propel the machine. It can be
identified by its black color.
The front brush is the softer brush and is intended to lift
and groom the carpet pile. It can be identified by the
white bristles.
Maintenance
Scrub brushes should be replaced as a set when bristle
length wears to height of yellow Perform AlertTM
bristles.
Scrub Brush Removal
The scrub brushes are removed from the right side of
the machine.
5. Disconnect all power and unplug machine.
6. Tip the machine back.
7. Pull out on the bottom of the retaining clip.
8. The brush assembly and end cap should drop
down. Then pull the brush down far enough to
clear the bottom of the housing.
9. Pull brush out with a rocking motion to free brush
from drive hub.
Bearing Cleaning
1. Remove bearing cap from end of brush.
2. Clean cap and bearings.
Scrub Brush Replacement
NOTE: See brush placement decal on brush deck.
(Black brush to rear of machine and white brush to
front of machine).
Only use the brushes provided with the appliance
or those specified in the instructions manual. The
use of other brushes may impair safety.
1. Lift the drive side of the brush and push it onto
drive hub until a positive stop is felt. The brush
cannot be installed until the brush is fully seated on
the drive hub.
2. Pull out on the bottom of the retaining clip.
3. Line up the end cap with the flats to each side.
4. Slide brush up into the retaining clip until it clicks in
place.
Only qualified maintenance personnel are to
perform the following repairs
Seul le personnel d'entretien qualifié peut effectuer
des réparations
.
Vacuum Motor Replacement
1. Turn off all switches and unplug machine.
2. Remove recovery tank.
3. Remove handle mounting assembly and set aside.
4. Disconnect and remove the solution/vacuum frame
assembly through the top of the machine.
5. Remove the vacuum motor to service brushes.
6. Reverse process to install vacuum motor.
86408790 Operator’s Manual - Clipper Duo