Windsor Chariot 2 CBAL20, Operating Instructions Manual

Page: 43 / 110

43
Maintenance
Battery Discharge Indicator Troubleshooting
The battery indicator flashes when a problem occurs. The table below list solutions for the indicated problems.
Number of
flashes
Problem Solution
1
The battery needs charging, there is a bad connection to
the battery or dependent on the programming, may
indicate that the battery lockout function is active and the
controller is in a restricted mode of operation. Check the
connections to the battery. If the connections are good, try
charging the battery.
2
There is a bad connection to the drive motor. Check all connections between the
motor and the controller.
3
The drive motor has a short circuit to a battery connection. Contact your service agent.
4
The battery charge level has fallen below the battery
Lockout Level and the controller is inhibiting burnisher
motor function. Charge the battery.
5
Not used. -
6
The controller is being inhibited from driving, this may be
because the battery charger is connected (on board
charger only). Disconnect battery charger.
7
A throttle fault is indicated. Make sure that the throttle is in the
rest position before switching on the
machine.
8
A controller fault is indicated. Make sure that all connections are
secure.
9
The parking brake has a bad connection. Check the parking brake and motor
connections. Make sure the
controller connections are secure.
10
An excessive voltage has been applied to the controller.
This is usually caused by a poor battery connection. Check the battery connections.
-
Blinks once every 5 seconds Sleep mode, cycle key switch
86356230 Chariot iGloss