Windsor Chariot 2 CBAL20, Operating Instructions Manual

Page: 29 / 110

29
Maintenance
Battery Charger Programming
NOTE: For machines equipped with optional on-
board charger. When replacing batteries, charger
programming changes may be required. If replacing
batteries with same type, (e.g. maintenance free
batteries with maintenance free) no programming is
required. When batteries with different type
(e.g.maintenance free with wet cell), programming
changes are required. Failure to make programming
changes may lead to reduced battery life.
Programming Instructions
The charger is pre-loaded with the charge algorithms
shown below:
Check Default Charge Algorithm
Enter Algorithm Display Mode:
1. Disconnect AC Power.
2. Remove positive lead from battery pack.
3. Apply AC power and the charger will display the
algorithm number after the Power On Self Test:
a. All algorithms will display as a series of flashes
of the 80% LED.
b. Algorithms #1 - 6 will also be indicated by the
Ammeter LEDs (see Users Guide).
Examples:
☼☼☼ =
Algorithm #3
☼☼
, Short Pause,
☼
= Algorithm #21
4. Algorithm number display repeats for 11 seconds,
then Algorithm Display Mode ends.
5. Remove AC Power and reconnect positive lead.
Check Default Charge Algorithm
1. Enter Algorithm Display Mode (as above).
2. While Algorithm Number is displayed (for 11
seconds), touch positive lead to the battery pack
positive terminal for 3.0 seconds (± 0.5s).
3. Remove lead from battery pack. Algorithm Number
will increment.
4. To increment the Algorithm Number again, repeat
Steps 2 and 3 within 30 seconds.
5. Touch positive lead to positive terminal and hold
until relay clicks (>10 seconds). The new default
algorithm is now stored.
6. Remove AC power and check default algorithm.
Contact your original equipment manufacturer if your
battery pack is not supported by the charge algorithms
loaded in your charger.
AlgID Description
1 Trojan J185H
5 Trojan 30XHS
42 Discover AGM EV31A-A
43 Discover AGM EV185A-A
86356230 Chariot iGloss