ASSEMBLY
86312550 02/05/09
5
1.
Fit the floor pad (11) to the bottom of the
burnisher, so that the pad will engage the pad
retainer (12).
2.
Push the floor pad down with one hand
against the resistance of the four orange
spring-loaded ejector pins. Fit the Quick-
release pad holder (13) with the other hand
and turn it clockwise until the lever arms click
into the floor pad. (11). The Quick-release pad
holder is fitted correctly when its lines (22) and
the lines on the floor pad (23) coincide.
3.
Push the telescopic tube (15) of your
vacuum(14) onto the swivel neck (5) of your
burnisher head.
PRECAUTIONS AND FLOOR PROTECTION
•
Not suitable for wet or uneven floors.
•
Do not operate the burnisher in a stationary position as this may damage the floor.
•
Do not operate the burnisher on soft floors.
•
Remove as much furniture as possible, and cover any that is left.
•
If heavy particles of dirt are not removed before polishing, small stones and grains of sand may damage
the floor.
•
Do not use on soft vinyl floors which are not properly attached or glued. They can be suctioned up or
damaged.
Summary of Contents for 8.631-213.0
Page 12: ...86312550 02 05 09 06048WI ...
