OPERATIONS
86312550 02/05/09
6
NOTE:
Follow the safety instructions in the manual
that comes with your vacuum.
NOTE:
Always check the cleaning and
maintenance instructions of your floor
manufacturer.
FIRST CLEANING
1.
Vacuum your floor thoroughly.
2.
Clean your floor with the appropriate cleaning
products for floor type.
3.
When floor is completely dry you may then
proceed.
USING YOUR BURNISHER
1.
Check to make sure the on/off switch (16) is in
the OFF position.
2.
Plug the machine into the electrical outlet.
3.
Switch the machine on.
4.
To start the machine, push the foot pedal (4)
down and tilt the handle (15) downward.
The burnisher has a soft-start system so there
may be a slight delay before it starts.
5.
Move the burnisher slowly over the floor in a
regular motion.
6.
When the finish can no longer be restored
repeat the First Cleaning process and then re-
polish the floors.
NOTE:
Failure to use the foot pedal will cause
lasting damage to the machine.
The foot pedal locks the swivel neck (5) in an
upright position. In this position the burnsiher
automatically turns off. The swivel neck has an
internal lock which will hold the machine in the
central position to avoid unwanted rotation.
LED-Display
The green LED light (1) indicates that the
burnisher is operational.
The red LED light (2) comes on if the machine has
shut down for safety reasons, for example,
overload or clogging. (See Removing Blockage
section.)
Summary of Contents for 8.631-213.0
Page 12: ...86312550 02 05 09 06048WI ...
