Windsor 1.005-294.0, Operating Instructions Manual, Page: 16 / 53

16
Operation
Pump
For priming the pump system for the first time, put the
yellow lever, which is located on the left side of the
machine in a vertical position
Hold down the black spray button on the right end of
the handle for about 30 seconds until the pump is
working at its full capacity.
This priming procedure should be repeated after every
change of the water tank. For standard priming 10
seconds is usually sufficient.
By adjusting the yellow lever you can vary the spray
pressure. The further you move the lever counter-
clockwise upwards, the higher the water pressure. A
horizontal position means maximum water output at
maximum pressure.
Adjust the spray jets on the machine base to the
desired position. For most floor cleaning applications
adjust the spray jets so that they spray about 6 inches
(15 cm) in front of the base.
86375030 Manual