WindSonic Doc No 1405 PS 0019 Issue 25 February 2017
12
6.4 Cable Assembly
Open the pack of parts provided with the WindSonic or as 1405-PK-069
Trim back the screened cable outer and screen sleeves 40mm.
Trim back the screen drain wires flush with the outer sleeve.
Strip back the connection wires by 5mm and tin solder.
Solder the contact pins to the wires (please note that the connector supplies the correct strain
relief for cables with an outside diameter of 6-12mm).
Put the parts on the cable in the order as shown below.
Whilst squeezing the red retainer in the direction of ARROWS A, pull in the direction of
ARROW B.
A
A
B
Your connector should now resemble the connector in the picture below.
Screen Twisted Pair Cable
5 mm
40 mm
Screen drain wires cut flush
WindSonic Doc No 1405 PS 0019 Issue 25 February 2017
13
Insert each contact pin until you feel a slight click. If you have inserted the contact into the
incorrect hole it can be removed at this point by simply pulling it out. Please note there will
be some resistance.
Rear View of Connector
1
9
5
3
7
4
2
6
8