13
Fig. 12
Hinging in air control at top
and screwing on at bottom
Fig. 13
Using cable ties to secure cables to the
boiler at the white/yellow marks
–
Fit air control on rear of boiler; hinge in air control at top and secure with screw at bottom – Fig. 12.
–
Route cables from air control and lambda sensor upwards at sides and secure to the boiler at the position
of the white/yellow mark on the cable using the cable ties of the same colour – Fig. 13.
Fastening clips
with yellow mark
Fig. 11
Installing the thermocontrol sensor
For the Installer
Fig. 10
Threading through thermocontrol sensor
–
Thread thermocontrol sensor (green cable) through boiler door rail – Fig. 10.
–
Fit front sensor at front above ash door – Fig. 11.
The air control cables must be long enough for service purposes and must not be routed around
the connection discharge.
Fastening clips
with white
mark
Installation sequence:
–
Carefully install the insulation on the top of the boiler – Fig. 8.
–
Attach control panel – Fig. 9.
Fig. 8
Fitting top insulation on the boiler
Fig. 9
Attaching control panel
