15
OPM-133/E
ENGINE CARE
MAINTENANCE SCHEDULE
* If engine use is infrequent; every year
** If engine use is infrequent; every 2 years
If you are using oil of a quality lower than the
recommended one then you will have to replace it every
150 hours
If major engine service or repair is required, contact an
authorized engine service center. The manufacturer of
these engines has established an excellent world-wide
engine service organization. Engine service is very likely
available from a nearby authorized dealer or distributor.
CHANGING THE OIL
Change the oil after the first 50 hours of operation and
yearly or 250 hours thereafter under normal operating
conditions.
Outdoor temperatures determine the proper oil viscosity for
the engines. Winco recommends our 5W-30 fully synthetic
oil to give you excellent protection in cold temperatures
while maintaining excellent performance in warmer
weather.
A. Change oil while the engine is still warm, the oil will
flow more freely.
B. Remove the oil drain bolt at base of the engine and
drain the oil into an approved container.
Daily or
Every 10
hrs
Every
250* hrs
Every
500** hrs
Check Oil
ü
Check oil filter
ü
Check dry air cleaner
ü
Fuel tank cleaning
ü
Clean cooling fins
ü
Replace engine oil
ü
Replace oil filter
ü
Replace fuel filter
ü
Set and clean
injectors
ü
Rocker arm
adjustment
ü
Drain Bolt
C. Replace oil drain plug.
D. Remove oil fill cap.
E. Fill to correct level with oil. Reinstall cap.
F. Remove the oil filter and dispose of it properly.
NOTE:
This engine requires 41.6 oz. (1.3 qts) of oil if it is
completely drained. Use caution when refilling the engine
as some residual oil may have remained in the engine.
Always use the dipstick when filling the engine with oil to
prevent overfilling.
H. Replace oil filter and filter plug.
I. Start the engine and warm it up.
J . After warming up the engine, recheck the oil level and
refill as necessary to bring it to the proper level.
CHECKING THE OIL LEVEL
The oil level must always be checked before the engine
is started. Take care to remove any dirt or debris from
around the oil plug before removing. Be sure the oil level is
maintained. Fill to the “FULL” mark on the dipstick.
AIR FILTER
Clean the filtering element with air blast. Air must be blown
from inside to outside the cartridge at a distance of at least
6 inches from the paper. Lightly and repeatedly tap the
element on a hard surface to eliminate all excess dirt.
WARNING: EQUIPMENT DAMAGE
Never start or run the engine with the air filter
removed.
A. Remove the cover.
Summary of Contents for W6010DE/I
Page 19: ...19 OPM 133 E WIRING DIAGRAM...
