Winco W6010DE/I, Installation & Operator'S Manual

Page: 9 / 20

9
OPM-133/E
Note: always make sure that a new battery is fully charged
before installing it on a generator set.
All connections must be clean and tight. Check the
electrolyte (fluid) in the battery periodically to be sure it is
above the plates. Never allow the battery to remain in a
discharged condition.
BATTERY CHARGING
Units have a small flywheel charger built into the engine
flywheel assembly for recharging the starting battery. This
flywheel charger generates a small AC current that passes
through a diode assembly to produce DC charging current
of about 1 to 3 Amps. This circuit is not designed to be used
as a battery charging circuit to recharge dead batteries.
LIFTING EYE INSTALLATION
In the bag of parts for the lifting eye, ensure all of the
required materials are included: 2 qty - 5/16-18 x 2.25
button head socket screws (#1); 2 qty - washers (#2); 2 qty -
.3125-18 flange (#3); 1 qty - lifting eye (#4).
1. Place the bottom of the lifting eye (#4) under the cross
bar (#5).
CAUTION: EQUIPMENT DAMAGE
Ensure the lifting eye is NOT installed on top of the
cross bar.
2. In each hole, place 1 washer (#2) between the top of the
cross bar and the button head screw (#1). Secure the screw
and flange, ensuring it is torqued.
OPTIONAL DOLLY KIT
An optional 2-wheel dolly kit is available for this generator.
The dolly kit comes with its own instructions and parts list.
CAUTION: EQUIPMENT DAMAGE
Be sure to check the wheels properly before operating the
generator.