Copyright 2014, WINCO MFG., LLC
15
GENERAL CARE & CLEANING:
•
REGULARLY lubricate pivot points on the recline mechanism with a lubricant approved by your facility. Periodically
position the chair back into full recline position to keep the gas cylinder lubricated.
•
Periodically inspect tightness of all screws, bolts, and nuts.
•
Winco furnishings are built to provide durable reliable service when properly cared for. In general all of our products
should be 1) Cleaned 2) Rinsed 3) Allowed to air dry. It is important to note that disinfecting a product is not the
same as cleaning the product. Disinfectants alone will not provide adequate cleaning, they do not have grease or oil
cutting properties to remove grime or hair and skin oils. Over time, the appearance and feel and performance of your
upholstery may diminish if not cleaned properly
CLEANING:
Remove grime, hair and body oils; Your furnishings should be cleaned with mild soap & water solution and a damp cloth
on a regular basis (especially where skin & hair make contact with upholstery). Avoid harsh detergents that could dam-
age the upholstery or finish of your recliner. If the furnishing is disinfected with bleach, it MUST be wiped off using only
clean water on a damp cloth and then be allowed to air dry. Failure to rinse upholstery with clean water can result in a
build-up of residues over time that can dry out the upholstery and cause changes to the look and feel of the upholstery
and eventually can lead to cracking.
WARNING:
•
When seat is removed, use caution cleaning in and around mechanisms. Keep hands clear of pinch points &
metal edges or injury may occur. Disconnect power (Chairs w/ HM or HT option) when cleaning chair.
6 7
GENERAL MAINTENANCE
GAS SPRING RELEASE ADJUSTMENT: (continued)
Chair will not recline:
6. If chair will NOT recline when left or right recline levers are pulled,
rotate the gas spring clockwise (A) half (1/2) of a revolution (or 180°).
Chair reclines without the use of recline levers:
7. If the chair reclines without the use of recline levers, rotate the gas
spring counter-clockwise (B) half (1/2) of a revolution (or 180°).
8. After adjustment; Replace Clevis Pin and Bow-Tie Cotter Pin.
9. Pull the recline lever (A) and push back on the chair back (B) to
check for proper adjustment. Repeat above steps as needed until
correct release action is achieved. Then TIGHTEN HEX NUT (that
you loosened in step 5).
IMPORTANT:
•
Make sure all bow tie cotter pins are securely inserted in all
clevis pins.
WARNING:
•
Failure to securely insert the bow tie cotter pins into the clevis
pin could cause the clevis pins to fall out and result in injury, or
damage to the chair.
A
9