Copyright 2014, WINCO MFG., LLC
13
OPTIONAL HEAT & MASSAGE OPERATION:
Control is located on the inside of right arm of chair. (Right is determined - as if sitting in the chair)
Heating: (Heating elements are located in the seat & back of chair)
Push HEAT button - See indicator light on switch
3 Lights
= High Heat / Bright Light
2 Lights
= Medium Heat / Med Light
1 Lights
= Low Heat / Dim Light
No Light
= HEAT OFF
Allow 5-8 minutes for back and seat to warm to desired setting.
Heat will automatically shut off after approximately 60 minutes.
(Timer resets each time switch is pressed)
Massage option:
(The massage option uses 4 separate motors located in the backrest of the chair. Two in the lower
backrest, and two in the middle (upper) backrest.
Push MASSAGE button
1X
= Lower Back / Low Intensity
2X
= Lower Back / High Intensity
3X
= Upper & Lower Back / Low Intensity
4X
= Upper & Lower Back / High Intensity
5X
= Alternating Upper & Lower Back
6X
= MASSAGE OFF
Massage will automatically shut off after approximately 15 minutes.
(Timer resets each time switch is pressed)
TROUBLESHOOTING:
•
With system disconnected from power source, use a DAMP CLOTH ONLY to clean switch, wiring or power pack
(located under seat frame).
•
If there is no heat or massage or flashing light on the switch - check power cord connections to wall outlet AND
connection of power cord to power pack unit under chair.
•
If switch displays a flashing light; Disconnect from wall, check all accessible wire connectors under chair for
possible loose connections, then re-plug into wall and test again.
•
If system still does not work contact Winco customer service: 1-800-237-3377.
OCCUPANT OPERATING INSTRUCTIONS
CORD STORAGE:
(Models with Heat-HT or Heat & Massage-HM)
To prevent tripping on cord, damage to cord, or damage to recliner, the
power cord should be coiled and stored in the "Hook & Loop" fastener
provided BEFORE moving chair or whenever heat & massage is not in
use.
HEAT
MASSAGE
HEAT ONLY
OR