WINAICO is a trademark of Win Win Precision Technology Co., Ltd.
SIM2205-01(EN)
9
6.1 Mechanical module mounting
WINAICO modules are suitable for both vertical and horizontal installation methods due to their high degree of stability.
The modules must be clamped in place at a minimum of 4 points.
Examples of correct mounting methods: clamps and mounting with screws.
The modules can be mounted on the substructure by clamps from the front or by screws from behind. The clamping
area (Figure below) for each fastening point must have an area of at least 135 mm
2
. A torque wrench must be used for
assembly. In the examples shown, the tightening torque (using M8 bolts produced from V2A) is 20 Nm. Use the existing
drilled holes for securing the module. Do not drill any additional holes (doing so will void the product warranty). Use
appropriate corrosion-resistant fastening materials and use washers to fasten the PV module.
When the aluminum frame is mounted on a bracket of different metal material, the two metal parts should be isolated
to avoid galvanic corrosion, especially for humid or coast areas.
Please ensure that the substructure does not touch the junction box even under load.
