WilTec 61950, Operation Manual

Page: 13 / 19

© by WilTec Wildanger Technik GmbH Item 61950 Page 13
http://www.WilTec.de
http://www.aoyue.eu 05 2021 -1
http://www.teichtip.de
Fitting/replacing the blade
•
Danger! Pull out the power plug first.
•
Remove the table insert by undoing the two countersunk head screws.
•
Undo the nut with a size 24 wrench on the nut itself and a second fork wrench on the motor
shaft to apply counter-pressure.
•
Important! Turn the nut in the direction of rotation of the saw blade.
•
Take off the outer flange and pull the old saw blade off the inner flange by dropping the blade
at an angle.
•
Clean the blade flange thoroughly before fitting the new blade.
•
Mount and fasten the new saw blade in reverse order.
•
Important! Note the running direction. The cutting angle of the teeth must point in running
•
direction, i. e. forwards (see the arrow on the blade guard).
•
Refit and set the riving knife (6) and the saw guard (4).
•
Check to make sure that all safety devices are properly mounted and in good working condition
before you begin working with the saw again.
Assembling the table width extension
•
Use the screws (19) and nuts (20) to fasten the table width extensions (8) loosely to the saw
table (1).
•
Screw the supports loosely onto the saw housing and onto the table width extensions.
•
Align the table width extensions level with the saw table.
•
Finally, re-tighten all screws.
Using the saw
On/off switch
•
To turn the saw on, press the green “I” button. Wait for the blade to reach its maximum speed
of rotation before commencing with the cut.
•
To turn the machine off again, press the red “O” button.
Cutting depth (fig. 1)
Turn the hand crank
(12) to set the blade (3) to the required cutting depth.
Turn
anti-clockwise
to obtain
a larger
cutting depth.
clockwise a smaller
Parallel stop
•
Stop height
◦
The parallel stop (15) supplied with the circular saw has two different guide faces.
◦
To change from the stop rail (14) to the lower guide face, you have to slacken the two
knurled screws in order to disconnect the stop rail (14) from the holder.
◦
Remove the two knurled screws through the one slot in the stop rail and insert them in the
other slot.
◦
Remount the stop rail on the holder.
◦
The procedure for changing over to the higher guide face is similar.
•
Cutting width
◦
The parallel stop (15) has to be used when you make longitudinal cuts in wooden work-
pieces.