© by WilTec Wildanger Technik GmbH
Item 61950
Page 12
05 2021
-1
Assembly
Warning!
Pull out the power plug before carrying out any maintenance,
resetting or assembly work on the machine!
Assembling the base frame
•
Turn the saw upside down and place it on the floor.
•
Use the washers and the hex screws
(19)
to fasten the 4 legs
(16)
loosely to the saw.
•
Now use the hex screws
(19),
the washers and the nuts
(20)
to fasten the longitudinal struts
(21b)
and the cross-struts
(fig. 5, 21c)
loosely to the legs.
•
Please note: The longer struts
(21a)
have to be used on the sides.
•
Finally, tighten all screws and nuts on the base frame.
•
Screw the additional legs
(16)
to the rear legs so that they point towards the rear of the machine.
•
Plug the rubber feet
(16a)
onto the legs
(16).
•
Mount the tool hooks on the side of a front leg.
Fitting/removing the saw blade guard
•
Mount the saw blade
(3)
on the riving knife
(6)
so that the screw fits through the hole in the riving
knife.
•
Do not tighten the screw
(19)
too far
– the blade guard
(4)
must be able to move freely.
•
To remove the saw blade guard, proceed in reverse order.
Warning!
The guard hood (4) must always be lowered over the workpiece
before you begin to cut.
Setting in the riving knife
•
Danger!
Pull out the power plug.
•
Set the riving knife
(6)
to the max. cutting depth, move it to a 0° position and lock it in place.
•
Remove the saw blade guard.
•
• Take out the table insert
(2).
•
• Slacken the fixing screw
(19).
Setting for maximum cuts
•
Push the riving knife
(6)
until the gap between the saw table
(1)
and the upper edge of the riving
knife
(6)
is approx. 10 cm.
•
The distance between the blade
(5)
and the riving knife
(6)
should be 3
–5 mm.
•
Re-tighten the screw
(19)
and mount the table insert
(2).
Changing the table insert
•
To prevent an increased danger of injury, the table insert should be changed whenever it is
worn or damaged.
•
Remove the saw blade guard
(4).
•
Remove the screws
(19).
•
Take out the worn table insert
(2).
•
To fit the replacement table insert, proceed in reverse order.
