®
30
MAINTENANCE
CLEANING THE CLAMP TEETH
Soak an old toothbrush, or old shoelace in rubbing alcohol.
Run the cleaning utensil through the clamp teeth.
Allow to dry.
Repeat every 1,000 pulls, refer to Total # of pulls for count.
CLEANING THE PULLER INNER SURFACE
Soak an old toothbrush, or old shoelace in rubbing alcohol.
Run the cleaning utensil through the puller inner surface.
Allow to dry.
Repeat every 1,000 pulls, refer to Total # of pulls for count.
CLEANING THE GLIDE RAILS
The glide rails should be cleaned with a soft cloth dampened
with alcohol. Run the cloth over the glide rails, and inside the rail,
removing any debris.
CLEANING THE TOUCH SCREEN
Gently wipe the touch screen with a CLEAN DRY cloth.
DO NOT put water or other liquids on the touch screen.
9.1 SERVICE
31
SERVICE
REPLACING THE ELECTRONICS BOX
If the electronics box becomes defective, it can easily be
removed and replaced.
Please follow the below steps:
1. Remove the two screws with the included hex wrench on
the underside of the machine as shown
2. Use the hex wrench to gently push up through holes where screws
were. The electronic box will pop up so you can remove.
(be careful to not damage the electronics cords)
3. Remove the three connectors
4. To insert a new electronics box, reconnect the connectors
5. Gently set the electronics box back into its location
6. Insert the two screws on the underside of the machine
Secure them tightly with the included hex wrench
View: underside of new electronics box.
Reconnect the electronics cords where indicated.