Wilson Electronics Alexandria XLF, Owner'S Manual, Page: 60 / 94

A
l e x A n d r i A
x l F O
w n e r
’
s
M
A n u A l
60
W i l s o n A u d i o S p e c i a l t i e s
• To find out which spike to lower,
grasp the Alexandria channel and
rock it back and forth. This will
identify the spike that is out of
level from the other three.
• Place a level on the front to back
oriented axis. If it is level, then
your Alexandrias are level. If the
bubble shows that the speaker is
leaning toward the front of the
room, you will have to lengthen the
front spikes down toward the floor.
If the bubble shows that the speak-
er is leaning toward the back of the
room (behind the loudspeakers),
you will have to lengthen the rear
spikes down toward the floor.
Section 4.8—Expansion Spikes
Place one end of the expansion spike sub-
assemblies into the last hole of the spike track.
Expand the sub-assembly until the upper end
comes into contact with the dimple in the mid-
dle of the brass spike pad found on the under-
side of the wing braces. Use box end wrenches (included) to snug the expansion spikes
securely (see Figure 22).
Section 4.9—Installing the Back Covers
Attach the cover over the resistor plate. The cover attaches using the same stainless
steel pin system as the grills (see Figure 23).
f
igure
23 - i
nStAll the bAck
c
overS
�