Wilson Electronics Alexandria XLF, Owner'S Manual, Page: 51 / 94

s
e C T i o n
4 . 4 — C
o n n e C T i n g T h e
u
p p e r
m
o d u l e s
’ s
i g n a l
C
a b l e
51
W i l s o n A u d i o S p e c i a l t i e s
tured exclusively for Wilson Audio. The design goal was to create a connector with supe-
rior overall sound quality, consistency, and longevity.
A note about these connectors: You risk breaking the binding post if they are over-
tightened. Use the supplied binding post wrench and tighten until just snug.
The upper range signal cables are labeled so that they can be easily attached to
their appropriate module. This is ac-
complished as follows:
• Locate the cable marked
“Lower Mid.” Dress this
cable through the handle
opening and connect this
cable to the lower mid-
range module (LMRM)
loudspeaker binding post
(see Figure 17).
• Locate the cable marked
“Front Tweeter.” Dress
this cable through the
handle opening and con-
nect it to the high fre-
quency module (HFM)
loudspeaker binding post
(see Figure 17).
• Locate the cable marked
“Upper Midrange.” Locate
the binding post on the
rear of the upper mid-
range module (UMRM)
labeled “Mid Frequency.”
Carefully thread the
speaker cable up through
f
igure
16 - i
nStAll the upper moduleS into the wing
ArrAY
�