11
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected]. Hours: 7 am to 6 pm MST.
12
Powering up a Wilson Electronics Signal Booster
Never point the front of a directional outside antenna toward the
1 .
inside antenna . See Figure 2 on page 12 .
Ensure that both the outside antenna coax cable and the inside
2 .
antenna coax cable are connected to the signal booster
and the
connections are tight
before powering up the signal booster .
Plug the 6-volt power supply into the signal booster input
3 .
marked “POWER” (carefully, to avoid damaging the center pin)
and then into a wall outlet .
If the signal booster does not have a green light, please see
4 .
pages 13 & 14 .
If you know that only one frequency band (800 or 1900) is
5 .
available in your coverage area (or going to be used), reduce
the gain control on the frequency band that is NOT in use to the
lowest setting . This will reduce the power consumption of the
signal booster .
Using multiple signal boosters in one installation may cause
6 .
interference to the cell tower .
Contact Wilson Electronics Technical Support Team with any
7 .
questions at 866-294-1660 or email tech@wilsonelectronics .com .
Technical Support hours are 7 am to 6 pm MST .
DB Pro™