WILSON AUDIO Sasha WP, Owner'S Manual

Page: 25 / 72

25
W i l s o n A u d i o S p e c i a l t i e s
S e c t i o n 2 . 1 – U n c r a t i n g t h e S a s h a W / P
Note: You will have two Upper Midrange/Tweeter Module enclosures as well as two
Woofer Module enclosures to unpack. The two modules will need to be separated into
right and left channels. Clear out two spaces, one for your left and one for your right
channels. Place the ODD numbered modules in the LEFT channel section and the
EVEN in the RIGHT channel position.
Section 2.1 – Uncrating the Sasha W/P
Initial Check
The Sasha W/P is shipped in three wooden crates. Upon receiving these crates,
please check their condition. If any of the crates are damaged, please report it to the
shipping company immediately for insurance verification.
The following items are recommended for this procedure:
• Electric Screwdriver
• Phillips head drive bit
• Masking tape (for use in speaker setup)
Uncrating the Woofer Module
A minimum of two strong adults is required to set up the Sasha W/P. Locate the
two largest crates labeled “Woofer Module.” These contain the woofer enclosures and
are the first components of the system to unpack.
1. With the crate lid facing up, unscrew the wood screws securing the lid.
Remove the lid.
2. Carefully turn the crate upright so that the Woofer Module is now verti-
cal. With the Woofer Module’s bottom toward the floor, reach in and
gently slide the Woofer Module out of the crate, carefully, so as not to hit
the Woofer Module on the crate and scratch the paint.
3. Place the Woofer Module with an odd serial number on the left side of
the room and the Woofer Module with an even serial number on the right
25