en
Installation and electrical connection
22
WILO SE 2019-01
Mounting the mixer on the lowering device
1
2
6
8
9
Fig. 8:
Mixer on the lowering device
1
Hoisting gear
2
Lifting equipment
6
Frame
8
Guide pipe for lowering device
9
Upper holder of the lowering device
‡
Mixer hangs horizontally.
‡
Frame perpendicular to the guide pipe.
‡
Cable bracket is installed.
1. Slowly lower the mixer.
2. Insert the guide pipe in the frame without tilting.
NOTICE! The guide rollers are in contact with the guide pipe.
3. Version with quick-release axles:
Lower mixer until the frame is below the upper holder. Install the quick-release
axles and plastic rollers and secure them with linchpins!
Completing installation
1
2
8
10
11
12
Fig. 9:
Mixer set down on the fixed limit stop
1
Hoisting gear
2
Lifting equipment
8
Guide pipe for lowering device
10
Connection cable
11
Cable bracket with snap hook, cable routing via lifting equipment
12
Cable bracket with snap hook, safeguard against falling
‡
Mixer mounted on the lowering device
1. Slowly lower the mixer.
2. Attach the connection cable to lifting equipment using cable brackets.
The connection cable is routed safely with the lifting equipment (e.g. wire rope).
CAUTION! If no cable brackets are used to route the connection cable, ensure
that the connection cable is not pulled into the propeller!
3. Lower the mixer to the end of the guide pipe or until it reaches the fixed limit stop.
4. Secure the connection cable to the railing or hoisting gear to prevent it from fall-
ing!
5. Check the swivel range of the lowering device.
Check the complete swivel range of the lowering device. The mixer must not bump
into any structures (fixtures, basin wall).
CAUTION! If the full swivel range cannot
be used, mechanically limit the swivel range!
6. Set the desired angle and install a screw to secure the lowering device against fur-
ther adjustments.
▶ Installation is complete. Lay the connection cable and make the electrical connec-
tion.
