en
Spare parts
30
WILO SE 2020-02
Faults
Causes
Remedies
The system is running with city
main water whereas the rainwater
storage thank is full
The control panel is in manual mode
Restore the correct functioning mode on the
control panel.
Despite the sufficient water level in the tank, the
float switch did not change the supply mode.
The cable is damaged or the float switch is
blocked inside the tank
Check the contacts or perform a visual control.
The system is automatically renewing the water
inside the break-tank (check chapter 6.2)
Nothing to do, it’s a programmed feature. Check
chapter 6.2.
The float valve in the break-tank
is not closing/water is draining
through the overflow
The float valve is defective or mechanically
blocked
Perform a visual check, and if needed remove the
break-tank in order to check the float valve.
Controller error codes
STEADY RED LED (Fig. 5, rep. 24) (press
the up/down arrows to see the default
code)
A01: Dry running
Check the water inlets and then press RESET to
restart the system
A11: Default detected on the float switch
or with the cistern pump (if installed) in
the rainwater storage tank
Check the float switch and the cistern pump (if
installed)
A21: Issue with the flow sensor
Press RESET to cancel the default. If it lasts, con-
tact the Wilo after-sales service
A02: Overvoltage
Check the electric network, then press RESET
A05: Issue with the pressure sensor
Press RESET to cancel the default. If it lasts, con-
tact the Wilo after-sales service
BLINKING RED LED
The system detected a default but tries a
restart after 5 minutes
Wait for the automatic restart (ART), otherwise
press RESET for a manual restart.
If a failure persists or cannot be solved, please contact a specialist or the nearest Wilo
after-sales service.
11
Spare parts
Contact a local retailer and/or the Wilo after-sales service to order spare parts.
Mention the article number of the system on the rating plate for a rapid processing of
the order or service request.
12
Disposal
Information on the collection of used electrical and electronic products.
Proper disposal and appropriate recycling of this product prevents damage to the envi-
ronment and dangers to your personal health.
NOTICE
Disposal in domestic waste is forbidden!
In the European Union, this symbol can appear on the product, the packaging or the
accompanying documentation. It means that the electrical and electronic products
in question must not be disposed of along with domestic waste.
To ensure proper handling, recycling and disposal of the used products in question,
please note the following points:
ƒ
Only hand over these products at designated, certified collecting points.
ƒ
Observe the locally applicable regulations! Please consult your local municipality, the
nearest waste disposal site, or the dealer who sold the product to you for informa-
tion on proper disposal. For further information on recycling, go to www.wilo-recyc-
ling.com.
Summary of Contents for 2551468
